Home > News > Content
Stamping Die Selection Principle
Nov 16, 2017

Selection principle of stamping die:

1, we must first consider the die set in "stampingdie", on the square set mold 1.5 analysis to the stamping line is greater than or equal to the length of the die for pressing, arc diameter is greater than the diameter of the inner circular die stamping die set is curve, if used.

2, can be incorporated into the basic graphic outline, first of all to die whether there is a library for stamping die and contour, the contour can be completely out of a punching action, if the mold, stamping die set in the selection of stamping die "will be ignored, so that direct stamping dies used to search.

3, when the long side of the rectangular outline, greater than or equal to 1.5 times the short side, will automatically search for whether there is a square and rectangle short side stamping die the same: whether there is a circular die groove width consistent on the oblong groove or round groove search, if there is a direct use of the die, after the above two steps yet sure dies, then consider the use of a square or circular die step punching die line or arc.

4, if the set die is not suitable, the system will press the mold library from small to large search square or circular die, use to meet the stamping straight line is greater than or equal to 1.5 times the length of the die.

Copyright © Suzhou Hongneng Tool & Die Co.,Ltd All Rights Reserved.Tel: +86-512-65690189